Sketch out the different materials (note Sketch lines cannot intersect ).Sketches for splitfaces can be stored in groups, if they touch incorrectly or touch a shaft or other joined element they will cause an error. This is fast but has a huge drawback - if the floor is deleted all information is lost.
SPLIT FACE: start splitting out areas for finishes.the materials should typically be set to finish2 and can be as simple as one layer thick Floor types should have a layer of the material representing the thickness of that material and any set beds.Use FINISHES-INTERIOR- for the floor types.1/4") and requires a 2" deep bed for mortar setting or shower drainage- it will show it. Recessed areas of the floor can be tagged using an elevation tag to show the top of the floor and the bottom of the floor relative to the level- so if the floor is slightly raised (i.e.
Separate from the main floor but can be joined to the main floor.